Post on 13-Jul-2020
RMX-400
V0.00817A
Extensor de control remoto por HDMI
Manual de instrucciones
PRECAUCIONES
CONEXIÓN
OUT
IN
CEC IR IR R
X
OUT
INCEC IR IR
RX
IR T
X
Antes de utilizar su nuevo producto Steren, lea este instructivo para evitar cualquier mal funcionamiento.
La información que se muestra en este manual sirve únicamente como referencia sobre el producto. Debido a actualizaciones pueden existir diferencias. Por favor, consulte nuestra página web www.steren.com.mxpara obtener la versión más reciente del instructivo.
IMPORTANTE
• No exponga el producto a temperaturas extremas.
• Siempre utilice un paño limpio y seco para limpiarlos. • Procure que el peso del cable no recaiga en el conector, esto puede provocar daños a su equipo. Si tiene soporte sujete el cable a este o a la pared para evitar daños
NOTA:Asegúrese de que el transmisor apunte directamente al equipo que desee controlar
Es necesario que se conecte el cable HDMI sin utilizar amplificadores, coples o accesorios HDMI para un óptimo funcionamiento.
En caso de que la distancia que desea conectar sea mayor a 20 metros utilice extensores para que pueda funcionar correctamente.
ESPECIFICIACIONESFrecuencia portadora: Dual Band (30 kHz – 60 kHz)Distancia de recepción del sensor: hasta 12 mCorriente máxima: 15 mA
Coloque ambos módulos en modo IR como se muestra en la imágen
OUT
IN
CEC IR IR R
X
OUT
IN
CEC IR IR R
X
Mode
VOL-
EQRPTU/SD
01
23
47
89 5
6
VOL+
SCN
Transmisor
TV
TV
Receptor
Control remoto de DVD
DVD
Cable HDMI máx. 20 m
IR T
X
OU
T INCEC IR
IR RX
RMX-400
V0.00817A
HDMI remote control extender
Instruction manual
CAUTIONS
CONNECTION
OUT
IN
CEC IR IR R
X
OUT
INCEC IR IR
RX
IR T
X
Before using your new Steren product, read this instruction manual to avoid any malfunction.
The information shown in this manual is for product reference only. Due to updates there may be differences. Please see our website www.steren.com.mxTo obtain the most recent version of the instruction.
IMPORTANT
• Do not expose the product to extreme temperatures.
• Always wipe with a clean, dry cloth. • Ensure that the weight of the cable does not fall on the connector, as this may cause damage to your equipment. If supported, attach the cable to this or the wall to prevent damage
NOTE:Make sure the transmitter points directly to the equipment you want to control
You need to connect the HDMI cable without using amplifiers, power cords or HDMI accessories for optimum operation.
In case the distance you want to connect is greater than 20 meters use extensors so that it can work properly.
SPECIFICATIONSCarrier Frequency: Dual Band (30 kHz - 60 kHz)Sensor receiving distance: up to 12 mMaximum current: 15 mA
Place both modules in IR mode as shown in the image
OUT
IN
CEC IR IR R
X
OUT
IN
CEC IR IR R
X
Mode
VOL-
EQRPTU/SD
01
23
47
89 5
6
VOL+
SCN
Transmitter
TV
TV
Receiver
Remote controlof DVD
DVD
HDMI cable max 20 m
IR T
X
OU
T INCEC IR
IR RX