boxchain cuadrada1

8/14/2019 boxchain cuadrada1

1/4

Pgina 1intable Archives

26/09/2009 17:00:25p://www.mailleartisans.org/articles/articledisplay.cgi?key=14342&view=print

Boxchain 4-1 (photos, ring flip method)Submitted by Elemental Dragon ( elementaldragon at yahoo.com )

The rings used in these pictures are made from aluminum ground wire. Approximate

measurements are 1/8"(.0125") wire diameter and 3/4"(.75") inside diameter makingit an approximate AR of 6. The use of these rings was so that I could work them by

hand and so that the weave was fairly open so that you could see what was

happening.

I find this method easier to understand than the stitch method. As they say, if you

have a problem, odds are that someone else has the same problem, so, having found

a solution to that problem that suits me, I will share it here so that others may

potentially benefit. I may not be the first one to construct boxchain with this method,

but it appears that I am the first to take the time to write it up and document it.

This method was developed from the Byzantine tutorial written by Kateryne. In fact,

it starts exactly the same way.

Please note that I will not refer to open and closed rings. Each mailler may do thingsin a way that is comfortable for them. The way I connect may be different than the

way you connect. I will leave it up to you as the mailler to decide.

Also note that I may get a little verbose with my text, so it may be less confusing to

look at the pictures.

Step 1: Connect 6 rings as pictured. A simple 3 link chain where each link consists

of 2 rings.


2/4



Step 2: With one pair of the end rings (marked with a "1" in these images), flip each

ring back, one to each side. You should end up with a configuration similar to what

is pictured.

Step 3: Spread the middle set of rings (marked with a "2" in these images) far

enough that you will be able to loop two rings between them and through the flipped

rings. See image for details.


3/4



Step 4: As indicated in the last step, loop two rings between rings 2 and through

rings 1. This completes and secures your first "box". Some of you may be able to

continue the weave from here. For those who can't, I'll do a few more steps to show

how to form a box with a box already there.

Step 5: Loop two rings through the two end rings of your previous unit.


4/4


26/09/2009 17:00:25p://www mailleartisans org/articles/articledisplay cgi?key=14342&view=print

Step 6: Flip the two newly added rings back (as in step 2) and spread the prior two

rings (as in step 3) to allow insertion of two more rings.

Step 7: Add two rings between the spread rings and through the flipped back rings.

Repeat adding, flipping, spreading, adding as neccesary to create the length of chain

you desire.

For practical use, you will probably want to use a smaller AR. Probably somewhere

in the neigborhood of 4.2 at the smallest AR.

Printed from M.A.I.L. - www.mailleartisans.org : Elemental Dragon | [email protected]

boxchain cuadrada1

Documents

Transcript of boxchain cuadrada1