Cigar box guitar paper model - Tabulatúra régizene-együttes · Cigar box guitar paper model cut...
1
C C i i g g a a r r b b o o x x g g u u i i t t a a r r p p a a p p e e r r m m o o d d e e l l cut and glue - string it with thread (the bottleneck slide - roll it on a pencil) 1. 1. 1. 1. (The inner support for the neck - fold and glue, use more if necessary, or a 2mm thick pizza box stripe instead) 2. 2. 2. 2. (The back of the neck and the frets - fold and glue on the support, and glue the whole neck onto the front cover, but don’t assemble the upper part with the tuning keys yet) (the cutout for the neck) 3. 3. 3. 3. (The cigar box - assemble it, but don’t close before the correct fixing of the neck to the inner side of the cover. Glue a small match or toothpick under the strings as a bridge) 4. 4. 4. 4. (Make 4 pinholes at the string support where indicated, and attach the threads with knots) 5. 5. 5. 5. (Before you fold and glue the tuning key part make 4 pinholes at the string support below the keys, and attach the strained threads, and fix them with glue) m ma a d d e e b b y y : : bwana Glue the dotted surfaces, fold in „Z”-shape the striped part, and glue it too. Don’t use fluid glue, fold the pieces along a ruler, and use 80+ gr. paper.
Transcript of Cigar box guitar paper model - Tabulatúra régizene-együttes · Cigar box guitar paper model cut...
��
CCiiggaarr��bbooxx��gguuiittaarr��
ppaappeerr��mmooddeell����
ccuutt aanndd gglluuee -- ssttrriinngg iitt wwiitthh tthhrreeaadd�
(the bottleneck slide - roll it on a pencil)
1.1.1.1. (The inner support for the neck - fold and glue, use more if necessary, or a 2mm thick pizza box stripe instead)
2. 2. 2. 2. (The back of the neck and the frets - fold and glue on the support, and glue the whole neck onto the front cover, but don’t assemble the upper part with the tuning keys yet)
(the cutout for the neck)
3.3.3.3. (The cigar box - assemble it, but don’t close before the correct fixing of the neck to the inner side of the cover. Glue a small match or toothpick under the strings as a bridge)
4. 4. 4. 4. (Make 4 pinholes at the string support where indicated, and attach the threads with knots)
5. 5. 5. 5. (Before you fold and glue the tuning key part make 4 pinholes at the string support below the keys, and attach the strained threads, and fix them with glue)
mmaaddee bbyy::
bbwwaannaa
Glue the dotted surfaces, fold in „Z”-shape the striped part, and glue it too. Don’t use fluid glue, fold the pieces along a ruler, and use 80+ gr. paper.
